Simplest Method of Making Your Own Colloidal Silver First, prepare the following materials: three 9-volt batteries, a glass of distilled water, two pieces of pure silver wire (.999 fine). (Note: in the UK, you can buy distilled water from Boots, or Superdrugs, or some other chemists.) Now, follow the following steps: 1/ Heat up the glass of distilled water to just below the boiling point. The purpose of this step is to improve the conductivity of the distilled water. (This step is optional.) 2/ Clean the silver wires (or silver electrodes) with alcohol. 3/ Insert the silver wires into the distilled water. Placement of wires is not critical, but they must not be touching each other. 4/ Connect a circuit in the following manner: see link at the bottom 5/ Wait for about 30 minutes, or until the distilled water becomes slightly yellowish. The yellowish solution is called Colloidal Silver. Caution: When the final solution turns milky white rather than yellow, the water you use may be mineral water rather than pure distilled water. This situation is very common in the UK, as bottled distilled water is not always available. Do not use mineral water to make colloidal silver. If one has to make colloidal silver out of mineral water, reduce the time duration in step 5, say from 30 minutes to 1 minute. Caution: If you end up with brown stuff in your colloidal silver solution, this means that you have left the process for too long. The brown stuff is silver oxide. Caution: Some …